ELCRES™ DMX1233 Hard Resin Transparent Clear Low DF UV Stabilized

High Flow, Improved Scratch Resistance & Better Dielectric Performance

LNP™ ELCRES™ DMX1233 Resin is a Low DF UV Stabilized Polycarbonate. Copolymer ELCRES with Good Flow Rate, Improved Surface Hardness for Better Scratch Resistance

The Material is Available in Transparent Clear

LNP™ ELCRES™ DMX1233 Resin has High Ductility and Better Chemical Resistance

The Grade is from the LNP™ ELCRES™ Copolymer DMX Series, which offers a Significantly Improved Surface Hardness 5-Times Higher Pencil Hardness than Standard PC

Independent Laboratory Tests, using the Pencil Hardness (1 kgf) Standard, these Materials Achieved an H Rating Compared to a Much Lower 2B Rating for Ordinary PC – Equivalent to up to Five Times the Hardness of the Standard Material.

The DMX Resins Surpassed Painted Acrylonitrile Butadiene Styrene (ABS), PC/ABS, and other Painted Resins, which only Achieved a Mid-range F Rating. Further, if the ELCRES DMX Resin Grades are Hard-Coated with Silicone or Acrylic, their Pencil Hardness Increases to 3H.

Eliminating the Need for Secondary Coating Operations, which may Provide Several Important Benefits to Manufacturers:

- Lower Costs by Avoiding the Purchase of Coating Materials and Equipment
- Reduced Cycle Time by Cutting Out a Secondary Processing Step and Avoid Environmental Impact from Volatile Organic Compounds (VOCs) Released into the Atmosphere from the Coating Process

ELCRES™ DMX1233 is a Transparent Clear ROHS Compliance Polycarbonate Resin

Material HDT, 1.82 MPa, ASTM A648, °C

3.2 mm, unannealed 121

Vicat Softening Temperature Rate

Vicat Softening Temperature rate, B50 = 139

Material MFI / Melt Flow Rate

Melt Flow Rate, 300°C/1.2 kgf = 21

Material Melt Volume Rate, MVR

N/A

Material Flexural Modulus

Flexural Modulus, ISO 178, 2 mm/min, MPa = 2303

ELCRES™ DMX1233 Resin are UL94 - HB @ 0.60 mm ~ 3.0 mm

ELCRES Main Page

Disclaimer

Any sale by SABIC, Its Subsidiaries and Affiliates (each a “Seller”), is Made Exclusively under Seller’s Standard Conditions of Sale (available upon request) unless Agreed Otherwise in Writing and Signed on behalf of the Seller. While the Information Contained herein is given in Good Faith, SELLER MAKES NO WARRANTY, EXPRESS OR IMPLIED, INCLUDING MERCHANTABILITY AND NONINFRINGEMENT OF INTELLECTUAL PROPERTY, NOR ASSUMES ANY LIABILITY, DIRECT OR INDIRECT, WITH RESPECT TO THE PERFORMANCE, SUITABILITY OR FITNESS FOR INTENDED USE OR PURPOSE OF THESE PRODUCTS IN ANY APPLICATION. Each Customer must Determine the Suitability of Seller Materials for the Customer’s Particular Use through Appropriate Testing and Analysis. No Statement by Seller Concerning a Possible Use of any Product, Service or Design is Intended, or should be Construed, to grant any License under any Patent or other Intellectual Property Right. © 2021

SABIC Innovative Plastics is a Trademark of SABIC Holding Europe BV * Cycolac, Cycoloy, Elcrin, Elcres, Lexan, Noryl, Ultem, Xenoy, Valox and Visualfx are Trademarks of SABIC Innovative Plastics IP BV © Copyright 2008 SABIC Innovative Plastics IP BV. All rights reserved.