BRINGING THE RIGHT MATERIAL & BEST SERVICES IN SOUTH EAST ASIA
Thailand Office : +66 88 874 7437
Malaysia Office : +6012 283 6969
Indonesia Office : +62 818 0402 0119
Vietnam Office : +84 934 036 679
Philippines Office : +63 917 567 4188
India Office : +91 988 439 6812
GELOY™ CR3020 ASA Resin. General Purpose Low Gloss Extrusion Grade
Weatherability, Good Flow for Aesthetic Capstock Profile over ABS
GELOY™ CR3020 ASA Low Gloss Extrusion Resin is a High Flow Resin and Low Gloss Finish
It offers Excellent Weatherability ( UV Stabilized ) for Capstock Profile over ABS in Co-extrusion
GELOY™ CR3020 is Best for Injection Molding or Profile Extrusion that can be Coextruded over ABS, PVC or other Compatible Polymers
GELOY™ PC/ASA Blends provide Improved Heat and Mechanical Performance, including up to 5 times the Room Temperature Impact Performance and up to 20 degrees Higher Heat Deflection of Standard ASA Products.
These Properties are Particularly Important for Applications that Typically Require a PC or PC/ABS Resin but their Environment requires UV Protection for Both Mechanical and Aesthetic Performance.
GELOY CR3020 ASA Resin has 0.5 ~ 0.7 Shrinkage, Flow, 3.2 mm. %
Material HDT, 1.82 MPa, ASTM A648, °C
3.2 mm, unannealed 77
Vicat Softening Temperature Rate
SABIC GELOY™ CR3020 Vicat Softening Temperature Rate , B50 = 99
Material MFI / Melt Flow Rate
Melt Flow Rate, 220°C/10.0 kgf = 5
Material Melt Volume Rate, MVR
N/A
Material Flexural Modulus
GELOY™ CR3020 Flexural Modulus, ASTM D790, 1.3 mm/min = 2130 Mpa
GELOY™ CR3020 Resin are Non UL Rated
Disclaimer
Any sale by SABIC, Its Subsidiaries and Affiliates (each a “Seller”), is Made Exclusively under Seller’s Standard Conditions of Sale (available upon request) unless Agreed Otherwise in Writing and Signed on behalf of the Seller. While the Information Contained herein is given in Good Faith, SELLER MAKES NO WARRANTY, EXPRESS OR IMPLIED, INCLUDING MERCHANTABILITY AND NONINFRINGEMENT OF INTELLECTUAL PROPERTY, NOR ASSUMES ANY LIABILITY, DIRECT OR INDIRECT, WITH RESPECT TO THE PERFORMANCE, SUITABILITY OR FITNESS FOR INTENDED USE OR PURPOSE OF THESE PRODUCTS IN ANY APPLICATION. Each Customer must Determine the Suitability of Seller Materials for the Customer’s Particular Use through Appropriate Testing and Analysis. No Statement by Seller Concerning a Possible Use of any Product, Service or Design is Intended, or should be Construed, to grant any License under any Patent or other Intellectual Property Right. © 2021
SABIC Innovative Plastics is a Trademark of SABIC Holding Europe BV * Cycolac, Cycoloy, Elcrin, Elcres, Lexan, LNP, Noryl, Ultem, Xenoy, Valox and Visualfx are Trademarks of SABIC Innovative Plastics IP BV © Copyright 2008 SABIC Innovative Plastics IP BV. All Rights Reserved.