BRINGING THE RIGHT MATERIAL & BEST SERVICES IN SOUTH EAST ASIA
Thailand Office : +66 88 874 7437
Malaysia Office : +6012 283 6969
Indonesia Office : +62 818 0402 0119
Vietnam Office : +84 934 036 679
Philippines Office : +63 917 567 4188
India Office : +91 988 439 6812
GELOY™ XP7550 High Flow ASA/PC Resin. Outdoor Injection Molding Grade
High Flow, High Impact Strength. Good Toughness, Good Heat Performance
GELOY™ XP7550 PC/ASA Resin is a General Purpose Grade for Injection Molding with High Flow Features
It offers High Heat and High Impact Strength.
GELOY™ XP7550 is Best for Injection Molding of Exterior Outdoor Applications
GELOY™ PC/ASA Blends provide Improved Heat and Mechanical Performance, including up to 5 times the Room Temperature Impact Performance and up to 20 degrees Higher Heat Deflection of Standard ASA Products.
These Properties are Particularly Important for Applications that Typically Require a PC or PC/ABS Resin but their Environment requires UV Protection for Both Mechanical and Aesthetic Performance.
GELOY XP7550 PC/ASA Resin has 0.4 ~ 0.6 Shrinkage, Flow, 3.2 mm. %
Material HDT, 1.82 MPa, ASTM A648, °C
3.2 mm, unannealed 89
Vicat Softening Temperature Rate
SABIC GELOY™ XP7550 Vicat Softening Temperature Rate , B50 = 105
Material MFI / Melt Flow Rate
Melt Flow Rate, 220°C/10.0 kgf = 14
Material Melt Volume Rate, MVR
Melt Volume Rate, 260°C/5.0 kgf = 26
Material Flexural Modulus
GELOY™ XP7550 Flexural Modulus, ISO 178, 2.0 mm/min = 2400 Mpa
GELOY™ XP7550 Resin are Non UL Rated
Disclaimer
Any sale by SABIC, Its Subsidiaries and Affiliates (each a “Seller”), is Made Exclusively under Seller’s Standard Conditions of Sale (available upon request) unless Agreed Otherwise in Writing and Signed on behalf of the Seller. While the Information Contained herein is given in Good Faith, SELLER MAKES NO WARRANTY, EXPRESS OR IMPLIED, INCLUDING MERCHANTABILITY AND NONINFRINGEMENT OF INTELLECTUAL PROPERTY, NOR ASSUMES ANY LIABILITY, DIRECT OR INDIRECT, WITH RESPECT TO THE PERFORMANCE, SUITABILITY OR FITNESS FOR INTENDED USE OR PURPOSE OF THESE PRODUCTS IN ANY APPLICATION. Each Customer must Determine the Suitability of Seller Materials for the Customer’s Particular Use through Appropriate Testing and Analysis. No Statement by Seller Concerning a Possible Use of any Product, Service or Design is Intended, or should be Construed, to grant any License under any Patent or other Intellectual Property Right. © 2021
SABIC Innovative Plastics is a Trademark of SABIC Holding Europe BV * Cycolac, Cycoloy, Elcrin, Elcres, Lexan, LNP, Noryl, Ultem, Xenoy, Valox and Visualfx are Trademarks of SABIC Innovative Plastics IP BV © Copyright 2008 SABIC Innovative Plastics IP BV. All Rights Reserved.