GELOY™ XTWE270M Extrusion Grade ASA/PC Resin. Average Gloss Outdoor

Good Flow with Good Impact Strength for Coextrusion over PVC or ABS

GELOY™ XTWE270M ASA Resin offers Unique Average Gloss Level with Standard Features

It offers Weather Performance. Best for Co-extrusion over PVC or ABS.

GELOY™ XTWE270M is Best for Injection Molding of Exterior Outdoor Applications

GELOY™ PC/ASA Blends provide Improved Heat and Mechanical Performance, including up to 5 times the Room Temperature Impact Performance and up to 20 degrees Higher Heat Deflection of Standard ASA Products.

These Properties are Particularly Important for Applications that Typically Require a PC or PC/ABS Resin but their Environment requires UV Protection for Both Mechanical and Aesthetic Performance.

GELOY™ PC/ASA XTW Series take Weather Ability to the Extreme. It offers Superior Color and Gloss Retention3 ~ 5 times better than Traditional ASA Resin

GELOY XTWE270M ASA Resin has 0.3 ~ 0.7 Shrinkage, Flow, 3.2 mm. %

Material HDT, 1.82 MPa, ASTM A648, °C

3.2 mm, unannealed 69

Vicat Softening Temperature Rate

SABIC GELOY™ XTWE270M Vicat Softening Temperature Rate , B50 = 82

Material MFI / Melt Flow Rate

Melt Flow Rate, 220°C/10.0 kgf = 9.7

Material Melt Volume Rate, MVR

Melt Volume Rate, 260°C/5.0 kgf = 2

Material Flexural Modulus

GELOY™ XTWE270M Flexural Modulus, ISO 178, 2.0 mm/min = 1870 Mpa

GELOY™ XTWE270M Resin are Non UL Rated

Return To GELOY Page

Disclaimer

Any sale by SABIC, Its Subsidiaries and Affiliates (each a “Seller”), is Made Exclusively under Seller’s Standard Conditions of Sale (available upon request) unless Agreed Otherwise in Writing and Signed on behalf of the Seller. While the Information Contained herein is given in Good Faith, SELLER MAKES NO WARRANTY, EXPRESS OR IMPLIED, INCLUDING MERCHANTABILITY AND NONINFRINGEMENT OF INTELLECTUAL PROPERTY, NOR ASSUMES ANY LIABILITY, DIRECT OR INDIRECT, WITH RESPECT TO THE PERFORMANCE, SUITABILITY OR FITNESS FOR INTENDED USE OR PURPOSE OF THESE PRODUCTS IN ANY APPLICATION. Each Customer must Determine the Suitability of Seller Materials for the Customer’s Particular Use through Appropriate Testing and Analysis. No Statement by Seller Concerning a Possible Use of any Product, Service or Design is Intended, or should be Construed, to grant any License under any Patent or other Intellectual Property Right. © 2021

SABIC Innovative Plastics is a Trademark of SABIC Holding Europe BV * Cycolac, Cycoloy, Elcrin, Elcres, Lexan, LNP, Noryl, Ultem, Xenoy, Valox and Visualfx are Trademarks of SABIC Innovative Plastics IP BV © Copyright 2008 SABIC Innovative Plastics IP BV. All Rights Reserved.