GELOY™ XTWM206 High Heat ASA/PC Resin with Excellent Weatherability

Good Flow, Improved Translucency, F1 Rated with Good Impact Strength

GELOY™ XTWM206 ASA Resin offers High Heat and F1 Rated for Injection Molding

It offers Weather Performance, Good Impact and Good Flow.

GELOY™ XTWM206 is Best for Injection Molding of Exterior Outdoor Applications

GELOY™ PC/ASA Blends provide Improved Heat and Mechanical Performance, including up to 5 times the Room Temperature Impact Performance and up to 20 degrees Higher Heat Deflection of Standard ASA Products.

These Properties are Particularly Important for Applications that Typically Require a PC or PC/ABS Resin but their Environment requires UV Protection for Both Mechanical and Aesthetic Performance.

GELOY™ PC/ASA XTW Series take Weather Ability to the Extreme. It offers Superior Color and Gloss Retention3 ~ 5 times better than Traditional ASA Resin

GELOY XTWM206 ASA Resin has 0.4 ~ 0.7 Shrinkage, Flow, 3.2 mm. %

Material HDT, 1.82 MPa, ASTM A648, °C

3.2 mm, unannealed 8.4

Vicat Softening Temperature Rate

SABIC GELOY™ XTWM206 Vicat Softening Temperature Rate , B50 = 95

Material MFI / Melt Flow Rate

Melt Flow Rate, 220°C/10.0 kgf = 8.8

Material Melt Volume Rate, MVR

Melt Volume Rate, 260°C/5.0 kgf = 9

Material Flexural Modulus

GELOY™ XTWM206 Flexural Modulus, ISO 178, 2.0 mm/min = 2380 Mpa

GELOY™ XTWM206 Resin are UL94 - HB, 1.50 mm ~ 3.00 mm Rated

Return To GELOY Page

Disclaimer

Any sale by SABIC, Its Subsidiaries and Affiliates (each a “Seller”), is Made Exclusively under Seller’s Standard Conditions of Sale (available upon request) unless Agreed Otherwise in Writing and Signed on behalf of the Seller. While the Information Contained herein is given in Good Faith, SELLER MAKES NO WARRANTY, EXPRESS OR IMPLIED, INCLUDING MERCHANTABILITY AND NONINFRINGEMENT OF INTELLECTUAL PROPERTY, NOR ASSUMES ANY LIABILITY, DIRECT OR INDIRECT, WITH RESPECT TO THE PERFORMANCE, SUITABILITY OR FITNESS FOR INTENDED USE OR PURPOSE OF THESE PRODUCTS IN ANY APPLICATION. Each Customer must Determine the Suitability of Seller Materials for the Customer’s Particular Use through Appropriate Testing and Analysis. No Statement by Seller Concerning a Possible Use of any Product, Service or Design is Intended, or should be Construed, to grant any License under any Patent or other Intellectual Property Right. © 2021

SABIC Innovative Plastics is a Trademark of SABIC Holding Europe BV * Cycolac, Cycoloy, Elcrin, Elcres, Lexan, LNP, Noryl, Ultem, Xenoy, Valox and Visualfx are Trademarks of SABIC Innovative Plastics IP BV © Copyright 2008 SABIC Innovative Plastics IP BV. All Rights Reserved.