BRINGING THE RIGHT MATERIAL & BEST SERVICES IN SOUTH EAST ASIA
: Vietnam : Indonesia : Thailand : Malaysia : Philippine : India
Thailand Office : +66 88 874 7437
Malaysia Office : +6012 283 6969
Indonesia Office : +62 818 0402 0119
Vietnam Office : +84 934 036 679
Philippines Office : +63 917 567 4188
India Office : +91 988 439 6812
LEXAN™ LS1 Resin. Transparent High Impact for Automotive Lighting
AMECA Listed for Vehicle Headlamp Lighting Application. Low Viscosity
LEXAN™ LS1 Resin is a High Impact General Purpose Polycarbonate Headlamp Lenses & AMECA listed
It comes in Crystal Clear Transparent and Can be Colored
LEXAN™ LS1 Resin is UL Rated HB across most General Part Thickness
This Polycarbonate Grade has added UV Stabilizer with High Flow Performance
Typical Applications for LEXAN™ LS1 Resin
- Headlight Lenses, Bezels, Reflectors, Inner Lenses, Housings, Thin-wall Lenses and Light Pipes
- Signal-lighting Lenses, Housings, Bezels and Reflectors
- LED Inner Lenses, Outer Lenses, Bezels, Housings, White Reflectors, Defuse Lenses, Heat Sinks and Plastic Aspheric Lenses, Frames or Carriers
- Fog Light Housings, Reflectors, and High-heat Lenses
- Projector Lens Holders, Reflectors, Plastic Aspheric Lenses, and Shutters
- RCL Lighting Housings, Bezels, Inner Lenses, Rear Lenses and Light Pipes
LEXAN™ LS1 Resin is UL94 HB - 0.75 mm ~ 3.00 mm
LEXAN ™ LS1 is a Transparent Clear ROHS Compliance Polycarbonate Resin
Material HDT, 1.82 MPa, ASTM A648, °C
6.4 mm, unannealed 129
Vicat Softening Temperature Rate
N/A
Material MFI / Melt Flow Rate
Melt Flow Rate, 300°C/1.2 kgf = 17.5
Material Melt Volume Rate, MVR
Melt Volume Rate, 300°C/1.2 kgf = 21
Material Flexural Modulus
Flexural Modulus, 1.3 mm/min, 50 mm Span = 2340
LEXAN™ LS1 Resin are HB@0.75 mm ~ 3.00 mm
Disclaimer
Any sale by SABIC, Its Subsidiaries and Affiliates (each a “Seller”), is Made Exclusively under Seller’s Standard Conditions of Sale (available upon request) unless Agreed Otherwise in Writing and Signed on behalf of the Seller. While the Information Contained herein is given in Good Faith, SELLER MAKES NO WARRANTY, EXPRESS OR IMPLIED, INCLUDING MERCHANTABILITY AND NONINFRINGEMENT OF INTELLECTUAL PROPERTY, NOR ASSUMES ANY LIABILITY, DIRECT OR INDIRECT, WITH RESPECT TO THE PERFORMANCE, SUITABILITY OR FITNESS FOR INTENDED USE OR PURPOSE OF THESE PRODUCTS IN ANY APPLICATION. Each Customer must Determine the Suitability of Seller Materials for the Customer’s Particular Use through Appropriate Testing and Analysis. No Statement by Seller Concerning a Possible Use of any Product, Service or Design is Intended, or should be Construed, to grant any License under any Patent or other Intellectual Property Right. © 2021
SABIC Innovative Plastics is a Trademark of SABIC Holding Europe BV * Cycolac, Cycoloy, Lexan, Noryl, Ultem, Valox and Visualfx are Trademarks of SABIC Innovative Plastics IP BV © Copyright 2008 SABIC Innovative Plastics IP BV. All rights reserved.