NORYL™ PX2630 High Impact Strength PPE + HIPS General Purpose Blend

Impact Strength, Low Warpage, Dimension Stability & Hydrolytic Stable

NORYL™ PX2630 PPE + PS Resin is a General Purpose engineering Thermoplastic developed to deliver enhanced Impact Resistance while maintaining Dimensional Stability across a Wide Range of Applications. This Non Reinforced PPE + PS Resin System is positioned for designs where Mechanical Toughness and Reliable Part performance are Primary selection Criteria.

Impact Performance is a defining characteristic of NORYL™ PX2630 PPE + PS Resin, allowing Components to withstand Mechanical Shock and Handling Stress without compromising Structural Integrity. This Toughness supports use in applications where resistance to Breakage or Damage is required during assembly or Service.

Dimensional Consistency is maintained through the Low Warpage behaviour and controlled shrinkage of NORYL™ PX2630 PPE + PS Resin, supporting accurate Part Geometry during Processing and End Use. These Characteristics enable stable Fit and alignment in General engineering Components without the need for reinforcement additives.

Environmental exposure Sensitivity is reduced by the Low Moisture Absorption and Hydrolytic Stability of NORYL™ PX2630 PPE + PS Resin, helping preserve Mechanical and Dimensional Properties over time. This Stability supports reliable Performance in applications subjected to Humidity or variable Environmental Conditions.

Environmental and Regulatory alignment is addressed through the ROHS Compliant Status of NORYL™ PX2630 PPE + PS Resin, supporting application in Products intended for Global Markets. This Compliance completes the material profile by aligning Mechanical Performance with Environmental responsibility.

Notes :

NORYL™ PX2630 PPE + PS Resin
High Impact Strength
ROHS Compliant

NORYL PX2630 PPE + HIPS has no data for Shrinkage, Flow, 3.2 mm. %

Material HDT, 1.82 MPa, ASTM A648, °C

6.4 mm, unannealed 126

Vicat Softening Temperature Rate

N/A

Material MFI / Melt Flow Rate

Melt Flow Rate, 250°C/10.0 kgf = 3.8

Material Melt Volume Rate, MVR

N/A

Material Flexural Modulus

2090

NORYL™ PX2630 are Non UL Rated

NORYL Main Page

Disclaimer

Any sale by SABIC, Its Subsidiaries and Affiliates (each a “Seller”), is Made Exclusively under Seller’s Standard Conditions of Sale (available upon request) unless Agreed Otherwise in Writing and Signed on behalf of the Seller. While the Information Contained herein is given in Good Faith, SELLER MAKES NO WARRANTY, EXPRESS OR IMPLIED, INCLUDING MERCHANTABILITY AND NONINFRINGEMENT OF INTELLECTUAL PROPERTY, NOR ASSUMES ANY LIABILITY, DIRECT OR INDIRECT, WITH RESPECT TO THE PERFORMANCE, SUITABILITY OR FITNESS FOR INTENDED USE OR PURPOSE OF THESE PRODUCTS IN ANY APPLICATION. Each Customer must Determine the Suitability of Seller Materials for the Customer’s Particular Use through Appropriate Testing and Analysis. No Statement by Seller Concerning a Possible Use of any Product, Service or Design is Intended, or should be Construed, to grant any License under any Patent or other Intellectual Property Right. © 2021

SABIC Innovative Plastics is a Trademark of SABIC Holding Europe BV * Cycolac, Cycoloy, Lexan, Noryl, Ultem, Valox and Visualfx are Trademarks of SABIC Innovative Plastics IP BV © Copyright 2008 SABIC Innovative Plastics IP BV. All rights reserved.