VALOX™ 310 PBT General Purpose Resin with Unique High Heat Stability

Good Stiffness, Excellent Chemical Resistance with Ease of Processing

VALOX™ 310 PBT Resin is a General Purpose PBT Material developed to provide a reliable balance of Mechanical Strength, Chemical Resistance, and Thermal Stability for a broad range of Industrial Applications

With its consistent Flow and Stable processing behavior, VALOX™ 310 PBT Resin supports the production of Dimensionally accurate Molded components while maintaining Good Stiffness and Structural Integrity during service

The Chemical Resistance of VALOX™ 310 PBT Resin allows finished Parts to Perform reliably when exposed to Oils, Greases, Fuels, And Common Industrial Chemicals without significant Degradation over time

VALOX™ 310 PBT Resin is commonly used in Electrical Components, Mechanical Housings, and General Industrial Parts where Cost effective performance and Long Term Reliability are required

UL94 HB rating applies to VALOX™ 310 PBT Resin at Thicknesses from 1.00 mm to 3.00 mm, supporting General Safety considerations.

Use of this Material aligns with ROHS Environmental Regulations for Global Markets

Notes:

VALOX™ 310 PBT Resin
General Purpose
ROHS Compliant Grade

VALOX 310 PBT has 0.90 ~ 1.60 Shrinkage, Flow, 3.2 mm. %

Material HDT, 1.82 MPa, ASTM A648, °C

6.4 mm, unannealed 54

Vicat Softening Temperature Rate

N/A

Material MFI / Melt Flow Rate

N/A

Material Melt Volume Rate, MVR

N/A

VALOX™ 310 Resin has a Flexural Modulus of 2340 MPa. 1.3 mm/min ASTM D790

VALOX™ 310 Resin are UL94 - HB, 1.00 mm ~ 3.00 mm Rated

VALOX Main Page

Disclaimer

Any sale by SABIC, Its Subsidiaries and Affiliates (each a “Seller”), is Made Exclusively under Seller’s Standard Conditions of Sale (available upon request) unless Agreed Otherwise in Writing and Signed on behalf of the Seller. While the Information Contained herein is given in Good Faith, SELLER MAKES NO WARRANTY, EXPRESS OR IMPLIED, INCLUDING MERCHANTABILITY AND NONINFRINGEMENT OF INTELLECTUAL PROPERTY, NOR ASSUMES ANY LIABILITY, DIRECT OR INDIRECT, WITH RESPECT TO THE PERFORMANCE, SUITABILITY OR FITNESS FOR INTENDED USE OR PURPOSE OF THESE PRODUCTS IN ANY APPLICATION. Each Customer must Determine the Suitability of Seller Materials for the Customer’s Particular Use through Appropriate Testing and Analysis. No Statement by Seller Concerning a Possible Use of any Product, Service or Design is Intended, or should be Construed, to grant any License under any Patent or other Intellectual Property Right. © 2021

SABIC Innovative Plastics is a Trademark of SABIC Holding Europe BV * Cycolac, Cycoloy, Lexan, Noryl, Ultem, Valox and Visualfx are Trademarks of SABIC Innovative Plastics IP BV © Copyright 2008 SABIC Innovative Plastics IP BV. All rights reserved.